Range of Hydraulic Pipe Couplings Manufacturer,Supplier and Exporter in India

Range of Hydraulic Pipe Couplings

Product Code : SCL-CELE-11928

OVERVIEW

The Hydraulic coupling is designed as an easy method of joining plain ended pipes in a vertical shaft. The coupling allows for expansion and contraction. It eliminate the expensive welding process, saves space and drastically reduces installation time. The Hydraulic coupling can only be installed in a system where each pipe is supported. The top and bottom pipes in the shaft must be properly anchored. The coupling allows for expansion and contraction and no other expansion joints will be required. All pipe ends must be properly prepared for the installation and must be free of scratches, dents or any damage. If the pipe ends are well prepared, and the coupling is installed as per the installation procedure, the chances of leaks are drastically reduced.

DESIGNED GAP

There should be a gap between the pipes when they are installed in the shaft. This gap will allow for expansion, contraction of the pipe and the center bolts / pins of the Hydraulic coupling. In most cases the design gap will be 25mm / 0,98". The design gap must be calculated and specified by the engineer, who is in charge of the design of the entire piping system. Should the design gap be greater than 25mm / 0,98", the face to face of the coupling will be greater than in the specified table below. 

LOW MAINTENANCE REQUIREMENT

All the moving parts of S-Range pressure reducing valve are manufactured from stainless steel which increases reliability and durability. The S-Range requires minimal maintenance, the majority of which, can be conducted with the valve remaining in situ. 

 

   

Office Address

Works: #975 Malleshwaram,
Bengaluru, Karnataka 560003

[email protected]

Follow Us